RMI 6, RMI 10
The RMA-6, and RMA-10 remote controls are designed for use with Ivie Technologies iFlex mixers. They consist of a set of six or ten remote control potentiometers built into a stand-alone “lap mixer” body. Over-all construction is very rugged.
Connection to the iFlex mixer is via a single Cat5E or better cable. Programming of the controls is done in the hardware programmer section of the Sonata software.
| • Each potentiometer may be assigned by iFlex Sonata software to control any level or combination of levels in a Sonata layout or design. • iFlex mixers can sense if the RMI-10 is present or not, and can be set to revert to levels preset in the layout if the mixer is not present. • Communication from the RMI-10 remote control to an iFlex mixer is by means of RS-485 over standard Cat5e (or better) cable. • A 25 foot length of supple, stranded-conductor Cat5e cable with black jacket is provided. The RJ-45 connector on each end is rubber booted for protection and strain relief. |
• Connection of the cable to the RMI-10 is by means of a robust RJ-45 connector in one side of the remote control body. • RMI-6 • Size - 8 1/2 x 4 x 1 1/2 in. • Weight - 12.3 oz. • RMI-10 • Size - 12 x 4 x 1 1/2 in. • Weight 1 lb. 3 oz. |